Dynamic tests
TEC Eurolab performs mechanical stress tests on your components
Check your product’s ability to withstand and distribute mechanical loads
Dynamic tests carried out at TEC Eurolab’s Test Engineering department.
- Custom tests for wear simulation
- Shock and impact tests
- Mechanical tests on real components
- Bending, tensile, compression tests with experimental set up
- Multi-axial fatigue testing
- Vibration tests
- NVH (Noise-Vibration-Harsness) acquisition and analysis.
Using pneumatic and electromechanical actuators, we configure a test set-up that faithfully reproduces the stress state that the component will encounter during its operational life.
REAL-TIME CONTROL OF ACTUATOR MOVEMENT
The real-time actuator motion control system will allow you to handle up to 4 axes simultaneously, with loads from a few newtons (required for biomedical components) up to 25kN (massive mechanical components). It is possible to program static or dynamic test cycles, according to a plan agreed upon your specific needs.
MODULAR TEST BENCHES
TEC Eurolab takes full advantage of the modularity of specific test benches.
In this way, any test setup can be set up to simulate all modes of mechanical stress.
In addition, by interfacing auxiliary control systems to the benches, set-ups for torsion tests and functional wear simulation tests can be realized.
The laboratory also has various sensor acquisition systems so that as much information as possible can be obtained: this will result in a detailed picture of the distribution of stresses and strains on the component.
Do you have a specific need for test design? Let's build your test plan together
Fill out the form. We’ll get back to you